Ocean Modeling Discussion

Kate, Thank you very much for your advice. I re-installed openmpi with macports using: $ sudo port install openmpi Now everything is ok. After installation, the location of mpicc and mpif90 should be added to paths. For my case The following line is added to .bash_profile: export PATH=$PATH:/opt ...

Actually, nothing is reported back. Seems I don't have mpicc. I followed the procedure from https://www.myroms.org/wiki/ROMS_Mac_Snow_Leopard and downloaded and installed opemmpi as stated before. Is there any step that I am missing? How can I adjust mpicc? soroushs-MacBook:~ soroush$ which mpicc ...

Thank you Kate, I made this change yet error persists as follows: $ ./configure CXX=mpiCC CC=mpicc FC=mpif90 CPPFLAGS=-I/opt/gfortransoft/openmpi/openmpi-1.4.5/include LDFLAGS=-L/opt/gfortransoft/openmpi/openmpi-1.4.5/lib --prefix=/opt/gfortransoft/openmpi/openmpi-1.4.5 checking whether the C ...

I looked into my config.log file. There are some other errors found there as follows: configure:2898: cc -E -I/opt/gfortransoft/openmpi/openmpi-1.4.5/include conftest.c conftest.c:9:10: fatal error: 'ac_nonexistent.h' file not found #include <ac_nonexistent.h> ^ 1 error generated. . . . configure ...

Moritz, Thank you very much for your response. I agree that mpif.h is probably not found or read. This file is located in: $ ll /opt/gfortransoft/openmpi/openmpi-1.4.5/include/ total 288 drwxr-xr-x 9 root wheel 306B May 17 20:53 . drwxr-xr-x 7 root wheel 238B May 17 20:52 .. -rw-r--r-- 1 root wheel ...

Hi, I have a similar problem with MCT on my mac. I am using macbook late 2009 Core 2 Duo. Procedure for installation of ROMS is followed based on https://www.myroms.org/wiki/ROMS_Mac_Snow_Leopard and The upwelling case is run successfully. Netcdf-3.6.3 is installed using post: https://www.myroms.org ...

Yea, its good that it works with netcdf-3.6.3, but I am not sure if some problem occurs at some point or not. At least I tested the upwelling case and did not face any error. Maybe it is due to version of netcdf too, not sure. It would be good if a new version of netcdf would work out as well. As ...

I could install and compile ROMS with netcdf-3.6.3. Thanks for assistance. In both netcdf cases, 'make check' command reported back an error. However, 'make' and 'sudo make install' worked out and netcdf versions were installed in desired paths. Despite this error, I tried to compile ROMS with ...

Jeremy, Thank you very much for your thorough response. I tried your solution, which worked out. However, I got into an error while compiling ROMS for Upwelling case, which will be addressed. The command used to configure netcdf-3.6.3 was as follows (after applying your adjustments and following ...

Hi, I am trying to install ROMS on Mac OS X El Captain. I am using Macbook late 2009 (64 bit). I consulted the tutorial on installing ROMS on OS X Snow Leopard (https://www.myroms.org/wiki/ROMS_Mac_Snow_Leopard). Xcode 7.3 is installed successfully. MacPorts-2.3.4-10.11-ElCapitan is installed ...